Water spraying around the handle is an external containment problem, separate from normal delivery at the outlet. A mist, stream or jet may help describe it, but spray shape alone does not identify packing failure or a cracked bonnet.
Keep away from wet electrical equipment. Do not touch wet appliances, plugs or switches, or enter water to reach a breaker. When no gas leak is suspected, power may be isolated only from a safely accessible dry location; otherwise call an electrician or emergency help. Wet equipment needs qualified assessment before it is used again.
Stop the spray safely
If safely reachable, close the faucet without force, then use its known effective homeowner branch isolation. If that does not contain the leak, use a safely accessible known main control or obtain urgent help. Stay out of the jet and wet electrical area. Do not tape over a pressure leak or tighten unknown parts while they are spraying.
Identify the actual part
Record the maker/model and the exact first wet point from safe observation. An exterior packing nut, bonnet retainer, decorative cap and integral breaker are not interchangeable. Look for visible damage only without forcing or opening parts. A body crack or leak entering the wall needs replacement or connection assessment rather than extra packing force.
When adjustment or replacement fits
Some makers permit a bounded external packing adjustment on the identified model without removing parts. Follow that instruction and stop at the stated limit if leakage persists or operation stiffens. No fixed turn count applies to all models. Internal packing, stem or body replacement requires the actual isolated service procedure.
Before removing a bonnet, packing, operating rod, cartridge or pressure-retaining breaker part, identify the exact model and its approved service procedure. Close a known effective homeowner supply control for every feed, control other connected inputs, and relieve and verify pressure at the actual serviced segment. A different indoor tap may not relieve an isolated outdoor branch. Stop if flow continues, the control is uncertain or parts bind. Use compatible approved parts and fully secure all pressure-retaining and protective components before an attended restoration. Re-isolate and verify relief before further disassembly. Cosmetic handle trim and maker-permitted external packing adjustment are different operations; neither authorizes loosening an unknown retainer under pressure.
Verify the repair
After a suitable fully assembled repair, restore the source as directed and observe both closed and normal open states with a known receiver. There should be no external spray. Re-isolate before further internal work. Persistent leakage, corrosion, binding or an uncertain source control calls for a plumber.
