Noise started after install

Garbage disposal area under the sink where a new noise started after installation.

New harsh grinding, metal contact or strong vibration after installation calls for stopping the disposal, not repeated listening runs. Keep the original sound, load and timing. Some models have normal startup or moving-lug sounds, but the description alone cannot establish normal operation or prove that a utensil is trapped.

Make the area safe before inspection

Stop affected use for overflow, active leakage, burning, harsh grinding or repeated trips. Stop added water and connected appliance discharge during backup. Do not touch wet electrical equipment or enter water to reach a plug or breaker; isolate only from safe dry access or get qualified help. Wet equipment needs assessment before reuse.

Before permitted manual work, set operating controls OFF and safely disconnect the actual affected power sources. Dishwasher hose work involves the dishwasher as well as the disposal. Never put hands or fingers inside the disposal, even when disconnected. Silence at a switch is not proof that wiring is dead. Keep electrical covers closed; altered or damaged wiring needs a qualified electrician. Re-isolate before further manual work after a powered step.

Separate an accessible object from mounting or electrical trouble

  • An object is visible: After safe source disconnection, use the model’s appropriate long retrieval tool from permitted access. Never reach into the chamber. Do not flush a heavy object away or use the motor to break it up.
  • A jam is suspected: Only use a tool the actual model specifies, at the designated access. A generic quarter-inch bottom hex method does not apply to every unit. Do not confuse freeing a moving lug with turning the drive plate.
  • The body or pipe vibrated: Ask the installer to assess the fully engaged mount, compatible outlet and pipe strain. Do not loosen the suspension to chase noise; support must precede any required mounting release.
  • A switch test was silent: That does not prove the appliance or wiring dead. Keep the actual source isolated for manual work and obtain qualified electrical assessment for altered wiring, burning, repeated trips or uncertain supply.

Use only the actual model’s jam procedure

A bottom wrench socket is not present on every disposal. Use only the specified tool and access; turning a drive plate, freeing a moving lug and retrieving an object are different tasks. Use approved long tools for retrieval, never hands. Do not pry out a fixed splash guard or force an inaccessible object. Keep the unit supported and do not loosen its suspension to clear a jam.

Before any permitted reset or brief check, remove the actual obstruction and all tools, restore required guards and covers, allow the specified cooling and keep the operating control OFF. Follow the model’s exact reset and power sequence. Only test after the drain and plumbing are ready and no electrical fault remains. Use the prescribed water flow; stop for hum, harsh noise, leakage, rise or another trip. Re-isolate before inspecting again. Food is not needed as proof that the obstruction is gone.

Is one quieter run enough to continue?

Only a suitable correction and the actual model’s safe return procedure can justify a limited check. A quieter run alone does not clear damaged mounting or electrical faults. Stop immediately if harsh noise returns, and re-isolate before any further inspection. Inaccessible objects, a jam that will not free or recurring vibration need appropriate service.

Related situations

Sources and limits

Manufacturer examples do not identify your installed model. This guidance has not had independent professional review or household field testing.

Find another plumbing guide

Need help with a different area? Choose a topic, then find the guide that matches your symptom.

Browse plumbing topics

Start with the affected area, then choose the guide that matches what happened.