Rotten smell after water heater replacement

Rotten odor after installing a new water heater

Check for an emergency first

If you smell fuel gas or suspect a gas leak, leave the building or affected area immediately and take others with you. Do not operate switches, plugs, phones, appliances, thermostats or valves in the affected area, light flames, or stay to ventilate or investigate. From a safe location well away, call the local gas emergency service or emergency services. Do not re-enter until responders say it is safe. Plumbing checks and normal maintenance must wait.

If a carbon monoxide alarm sounds or you suspect carbon monoxide exposure, get everyone outside immediately and call emergency services from safety. Carbon monoxide has no smell; an odor comparison cannot rule it out. Do not restart or repeatedly cycle a fuel-burning heater to investigate a possible combustion problem.

A rotten-egg smell after a water-heater replacement needs an initial distinction between a possible room-air gas hazard and an odor already noticed in water. Do not assume it is harmless factory residue. Sulfur-related water chemistry is one possible explanation, but smell alone cannot establish it or clear a new installation.

For a new, unexplained water-quality change: do not deliberately taste the water. Use bottled water or another known-safe supply for drinking, food preparation, teeth brushing and ice while you contact the supplier. Follow the actual local notice for other uses. Boiling does not make chemically contaminated water safe, and clear appearance or a fading odor does not certify safety.

Useful details to record

  • When the odor began relative to installation and whether it was noticed in room air before water ran.
  • Whether hot, cold or mixed water was involved during ordinary use; do not draw new cups or run a shower to compare smells.
  • Heater model, installer, water source, softener use and any documented commissioning or disinfection.

What the pattern can tell you

  • A room-air gas leak is suspected. Use the leave-first response above. Do not operate the heater, hunt for the source or stay to open windows.
  • Only hot-water use had revealed the smell. The heater and hot-water path are relevant to the service check, but that observation does not diagnose an anode reaction.
  • Cold water or several homes were also affected. Give those facts to the supplier. They do not exclude a separate installation issue.

What to do next

  1. Call the installer with the equipment and event history after any emergency has been handled. Ask for a check of commissioning, water connections and any fuel-burning installation concerns.
  2. For an unexplained change in water, contact the supplier or a certified laboratory about the relevant assessment before more flushing or treatment.
  3. If a water-chemistry cause is established, ask the technician about a remedy appropriate to the actual model and supply. Manufacturer guidance recognizes sulfur-related odor, but that is not a diagnosis of your tank.
  4. Keep the anode and other protection in place. Do not permanently remove an anode, shock-disinfect the tank, raise temperature or repeatedly heat water as a generic odor cure. Model-approved owner maintenance may be appropriate after assessment.

Should I wait 24 to 48 hours for a new-heater smell to fade?

Not when a gas, combustion or unexplained water-quality concern remains. A fixed waiting period cannot clear those hazards. Ask the installer or supplier what finding, test or corrective step addresses the actual concern and when to follow up.

Related situations

Safety sources

Find another plumbing guide

Need help with a different area? Choose a topic, then find the guide that matches your symptom.

Browse plumbing topics

Start with the affected area, then choose the guide that matches what happened.