No or very little delivery beyond a reducer needs the actual pressure-loss region identified. An upstream reading with a near-zero downstream reading does not alone prove a stuck-closed PRV.
Safe first steps
Keep away from wet electrical equipment. Do not touch wet appliances, plugs or switches, or enter water to reach a breaker. When no gas leak is suspected, power may be isolated only from a safely accessible dry location; otherwise call an electrician or emergency help. Wet equipment needs qualified assessment before it is used again.
For leakage or severe abnormal pressure, use a known safely accessible permitted owner control without force or request prompt supplier/plumber assistance. Keep away from wet electrical equipment. Do not operate supplier meter/curb controls, protective test cocks or unknown shared valves by guesswork. A normal safe owner operation differs from experimenting on a failed assembly.
Keep the useful evidence
- Actual two measurement points and every valve, screen and pipe segment between them.
- Known supplier availability, model and recent service/isolation history.
- Which outlets are already affected, without leaving taps open for a sudden restoration.
Interpret the actual conditions
An intervening closed valve, blocked strainer, pipe restriction, wrong gauge point or unavailable feed can change the result. Even two apparently close points need actual topology and instrument validity before selecting a complete replacement.
What to do next
- Check actual supplier/work information and pause equipment that cannot operate without water under its instructions; do not open meter controls to prove supply.
- Do not hammer, force, bypass or repeatedly work the regulator to free it.
- Have suitable actual upstream/downstream evidence establish the affected region and identify intervening components.
- Use model-specific isolated assessment of screen, moving parts and serviceability if warranted; near-zero pressure alone does not select a failed part.
- Fully secure the system and use actual controlled restoration after the cause is addressed. Do not leave outlets unattended while experimenting.
Before internal service
Before any internal service or fitting removal, identify and isolate every supply that can pressurize the section, release trapped pressure through the appropriate controlled outlet and verify depressurization. Account for hot water and possible alternate feeds. Lowering a PRV setting, reducing flow or wearing gloves does not make a pressurized assembly safe to open. If isolation cannot be established, leave it assembled and obtain qualified help.
Identify the actual model and whether screen access, seat/module service and spring-cage removal are separate procedures. Water-pressure release alone does not establish that a mechanical spring is unloaded. Follow the complete actual pressure, spring-release, compatible-part and reassembly method; comfort with tools is not a substitute. If safe isolation or the procedure is uncertain, leave the assembly intact and obtain qualified service.
Keep all relevant supplies isolated while any retained component or connection is open. Fully reassemble compatible rated parts before controlled restoration and leak/function checks. Any specified construction or service flush needs its relevant securely connected path, source-off refitting and accepting discharge; never reopen supply into an exposed pipe aimed at a bucket. Whole-house/hot flushing is not a default diagnostic or water-quality clearance.
Should I replace it whenever upstream pressure exists and downstream is zero?
That shows a difference across the measured region, subject to instrument validity. Identify the actual intervening controls/restrictions and cause before choosing repair or replacement.
Related guides
- How to test PRV failure
- PRV causing low water pressure everywhere
- PRV stuck open symptoms
- PRV clogged by sediment
- Pressure Regulator (PRV) Failure Patterns
